BREnterprises2011 Store Neat old gear. Center hole is octagon, 5/8" across. Weigh nearly 3 lbs.Neat old piece. Steampunk decor. Thanks.

 

GROUP OF TYPEWRITER KEYS FROM A MONARCH 3 TYPEWRITER. NEED CLEANED. Most of the items we sell are vintaged or used. We try to describe them as accurate as we can, however we might miss a DETAIL in the

 

Remington Rand typewriter. Made in USA seems to be in good working condition. I typed a bit with it and it worked great. No sticky keys. That is about all i know about this machine. Helping mom clear

 

PAIDAR BARBER CHAIR SINGLE POST HEADREST W/ PAPER ROLL BAR, VERY GOOD CONDITI0N COMPLETE WITH PAPER ROLL HOLDER, ORIGINAL UPHOLSTERY SHAFT IS 12-1/2" LONG SHAFT WIDTH IS 1-1/4" SHAFT THICKNESS 1/4" AC

 

You are bidding on Lot 116: a vintage set of 3 steel sprockets. The dimensions of the pieces are (width of gear, thickness/height and center opening) The dimensions of these pieces are 3--6 1/4" X 7/8

 

VERY DURABLE, HEAVYWEIGHT & WELL MADE. functional. SEE PICTURES. i am told that the plates that on the scale are not original- but they seem to be a perfect fit- although when i put them on the sc

 

I have not been able to find much info on this early motor. i think it was for a foundry or blacksnith blower. i have not tested it for fear of doing damage. it spins freely though. i cleaned it light

 

THIS ANTIQUE ITEM WAS MADE IN THE USA by UNDERWOOD, ELLIOTT & FISHER CO. SERIAL # P1096215, PLEASE BID ON THIS ITEM AS IS, I DON'T KNOW IF IT WORKS AS IT SHOULD, I KNOW NOTHING ABOUT TYPEWRITERS,

 

#158 English Miniature Roman Shuttle

 

This is a petite 3-1/2" x 2-1/2" cast iron embosser introduced by R. Woodman of Boston, Mass. in 1876. It is called the Centennial Check Protector. Both sides of the embosser have a raised dot surface