Functional Wrought Iron Atractive Rustic Blacksmith door or gate latch slide bolt locks bolt shutter latch StrongLong: 34,5 cm (13,5 inches) Open. Approx. IN GOOD CONDITIONIt is not a reproduction, it

 

For auction is a vintage German-made one crosscut saw with helper handle. Blade measures 33 inches; saw is 38 inches overall. Tooth pattern is M or crown--common Euro pattern--sharp with .012 factory

 

Excellent Dowelling jig by Record, Complete, No 148 This Record dowelling jig is a very useful item.Can be used for 5 different sized imperial & Metric dowels.Sleeves are 1/4 ", 6mm, 3/8", 10mm, a

 

This set of Ridgely Graining Combs is in a thin steel case with a gold tone. The case is badly scratched and the label on the back side is partially gone. There are four different width sets: 1 inch;

 

CUSTOM Raised Arch Tinsmith Stake... Here is a custom made one of a kind Tinsmith stake that is work ready... The stake is in excellent condition and has been well cared for.. The working surface is s

 

Here is a HTF vintage Keen Kutter No 7C corrugated bottom Jointer plane offered by E. C. Simmons Co from 1906 thru 1912. The plane is 22" long with a 2 3/8" wide extra thick cutter with the wedge and

 

Check out the pictures below, for some auctions there may be more than shown above. Marked on the back KEEN KUTTER and 9 for the 9 inch blade length. A little light surface rust to clean off and a sha

 

UNIQUE SET OF TONGS.18 INCHES LONG. NOT SURE IF BLACKSMITH TONG OR USED AS GLASS BLOWING TONG.

 

Here is a nice set of Stanley No. 100RJ auger bits in their original roll. Thirteen bits sized in 1/16" increments from 4/16" to 16/16" or 1/4"-1". These are from the Australian production timeline an

 

Craftmans Vintage planes