This listing is for a VINTAGE "KENNEDY" No S-19 ALL METAL HEAVY DUTY LOCKABLE TOOL BOX with PULL OUT TRAY INSIDE. The tool box is in very good & solid condition and no cracks, dents , but some spo

 

HARD FLAT STEEL ANVIL

 

NICE 5/8" HELLER Punch Hammer... Here is a nice larger size punch hammer that has seen light normal use.. The punch tip is in very good condition and measures 5/8" wide and expands to approx. 1 1/4" a

 

This Fine set of Buck Brothers socket chisels is ready to go back to work. The bevels have been precision wet ground and honed sharp. They are sized as follows: 1-3/4" x 9-1/4" (from the edge to back

 

Here we have another Keen Kutter Plane, a KK 5 C with a corrugated bottom. This is one of the most common of the bench planes offered by the E. C. Simmons Co from 1906 thru 1912. The plane is 14" long

 

Japanese Oire Nomi / Butt Chisel - THIN BLADE Vintage Ryu-no-Tsuke butt chisel in good condition. Listing as received. Professional quality chisel by the maker Ryu-no-Tsuke. dense metal and well-balan

 

Used Vintage BINKS No 85 Air pressure adjustment guage. Tire paint tank regulator. Stamped : Binks No 85 200 binks MFG CO. 0 - 150. Lbs/in 2 Kg/cm 2. Untested sold as is for parts, Restoration, Refurb

 

This vintage plane has surface rust with some paint spots and the front knob has age cracks. It measures 11 1/2" x 2 1/8" and the 1 3/4" blade has a chipped corner on the edge.

 

This auction is for a BOX-LOT of --Machinist Tools and Stuff. I recently found three metal tool boxes full of stuff. I know nothing about these types of tools and stuff so will be offering several box

 

This is a vintage HB single bit axe head that is made in sweden and in good condition and free of wood. It is 6 7/8" end to end and 3 3/4" at bit. The head weighs 2 lbs 5 ozs I took several close up p