This is a 18mm bench chisel by Kenji Yamada. New old stock(Never used) Overall length:220mm Blade length:55mm Neck length:43mm Kenji Yamada was a skilled chisel blacksmith in Nigata Prefecture.But he

 

Up for auction is this vintage Crescent Tool Company Jamestown, New York, Eclipse Trademark No. 13 adjustable nail puller. It is in good used condition and the markings on it are really neat! My dad s

 

Here is a vintage mini set of calipers in used condition. The calipers are in good working condition. Be sure to check out my other auctions you never know what you will find. Important note about shi

 

Unusual Stanley markings, 5 1/2 on frog bottom, O on blade and USMC on chip breaker. Only apology a chip off the side of the heal, as shown in both pictures. The Tote hold down screw is brass too, I h

 

These auger bits appear to be new, unused. Two 7/8" x 8 1/2", three 7/16" x 8", and one 1/4" x 7 1/2". They are Irwin brand and are "modern", not antique. Ready to use where you don't have electricity

 

This is an excellent wood turning parting tool by Robert Sorby.The 6 1/2" long blade is clean and sharp, total length 17".Blade is 3/4" x 3/16".The ash handle is in very good condition with a good bra

 

I have for auction this vintage Pike hard arkansas sharpening stone. It is in Fine Barely used condition. It is flat and ready to use. If this stone was used 3 times I would be surprised. It's conditi

 

THIS A PARK 3 DRAWER MACHINIST TOOL BOX20" ACROSS AND 10 1/2" TALL TOOL BOX IS IN GOOD CONDITION LATCHES ARE RUSTY BUT WORK FINE DRAWERS LOCK IN PLACE WITH TOP LID SHUT I DO NOT HAVE THE KEYHAS I INSE

 

Antique Vintage Stanley Sweetheart No 25 8" Sliding T-Bevel Rosewood Brass Tool. No previous owner marks. No cracks in wood handle. Very good condition.

 

I have for auction this Nice hardly used house hold anvil. It is 7 pounds 5 ounces. It is 8 inches long from the tip of the horn to the back of the table. The table is 2 1/8''. And the anvil stands 4