FOR SALE A VTG. SINGLE BIT AXE HEAD / PLUMB. IT DOES HAVE A FEW SMALL NICKS, BURRS, SCRATCHES AND TANISH. IF CLEANED UP THERE MAY BE SOME SMALL PITTING. BLADE LOOKS GOOD WITH JUST A COUPLE TINY NICKS.

 

This auction is for a GLASKIN MFG. CO. "ATOMIC" COMBINATION FENCING TOOL. HAMMER, CLAW, PICK, SLOTTER. It is made of cast iron and was patented by James B. Glaskin of Colorado Springs, CO. There have

 

For sale - 7 inches in overall length on this nice pair of early tools - Questions welcomed.

 

This is a Heller 8" Master Wrench. Made in USA. Has a picture of a horse on the handle. It is 8-1/2" long and works good. No breaks or repairs. WINNING BIDDER TO REPLY IN THREE DAYS AND PAYMENT TO BE

 

Vintage electric soldering iron Montgomery Ward no. 84-6053 100 watts. original box show considerable wear. Has new replacement tip in box. Cord is in excellent shape. takes a bit to heat up then hold

 

7 - Great Tools!!! 5 - Pfeil Swiss Made:12/6 - 6mm V-Tool (Full size -10") has some very minor pitting - but does not effect the cutting edge2/12 - 12mm #2 Sweep (NEW! Never used - Full size -10")D 5/

 

This very small level is 3 inches long by 2 inches high. The three levels are all good. It shows some use but it is a nice little level. Buyer pays actual shipping. Shipment to USA and Canada ONLY. In

 

I am listing to sell this vintage Delta hinged table extension. This is used, measures 12" in length, 5- 1/4" in width, due to its age there could be some surface rusting, scrapes, dings, scuffs but s

 

REAL NICE UNUSUAL PLUMB HATCHET USED VERY LITTLE CROSS HATCHING ON FACE, LIGHTWEIGHT WITH HANDLE 1LB. 2OZ. HEAD MEAS.APPROX. 6 9/16" TALL,CUTTING EDGE 2 3/16" FACE 1 3/8" X 1 1/4' "SOME RUST SPOTS SCR

 

MADE IN ENGLAND -- 26 - POINT - DOVE TAIL SAW -- ITS - 9 - 5/8 - INCHES LONG OVERALL -- THE BLADE IS - 5 - 1/16 - LONG -- 5 / 8 - OF AN INCH UNDER THE BACK -- HAS A BRASS BACK & COPPER FERRULE --