black diamond files & rasps.USA.

 

The item offered here is the micrometer holder. But, the micrometer shown, ground off on the back side of the frame, comes with it. The holder is cast iron with a 5/16in slot. The base is 2-3/4in diam

 

This Auction is for A 9" Antique Draw Knife The only markings I saw on it were in the middle of the blade "Oak Leaf" "Made in U.S.A." Blade is 9" long and total length is 14 1/2" long. There's a coupl

 

YOU ARE BIDDING ON: LOTS OF 6 JUNK DRAWER MIXED OLD VTG WOODWORKING HAND SAW ANTIQUE TOOL.THESE ARE GRAND FATHER JUNK TOOLS, PLEASE CHECK THE PICTURES BEFORE BIDDING. I DO COMBINE SHIPPING.

 

Rare Vintage Snap On Carry A long toolbox! Possibly a KRA-65B? This tool box functions as it should minus the locking mechanism and the draw slides either way out! VERY EASY TOOL BOX RESTORATION! Noth

 

Here is a classic Craftsman labeled version of the Stanley 78 rabbit plane in as-found condition. This one has made in USA cast into the side. These were probably made for Craftsman by Stanley or Sarg

 

DETAILS: Vintage Fulton Flashlight U.S. Mines approved Uses 2 D cell batteries (not included) Works just fine No cracks or known leaks in case Comes with spare bulb There was a little corrosion on ins

 

This item is in good condition. Handles and knobs are all firm. It weighs 2.4 pounds. Needs some cleaning .NO CUTTERS.

 

Huge lot of drill bits with drill bit indexes and some chuck keys. The largest bit you see (laying top left) on the table is a 9/16." I counted a little over 140 drill bits in all. The bits (about 10)

 

I HAVE UP FOR AUCTION AND YOUR CONSIDERATION A VERY OLD LEVEL. "STANLEY PAT. JUNE 23, 98" ACROSS THE SMALL LEVEL. THIS METAL LEVEL MEASURES 3 1/8" LONG X 5/8" WIDE. CONDITION: VERY GOOD..LEVEL WORKS G