Home




Harris Plane
$87.55 USD

Sold on: 2013-May-13

Marketplace: eBay
4 Treasure
0 Trash
100%


Detail:

harris plane body is 14" long 3 1/4 wide cutter is angled 2 1/2 " wide 3/16" thick




More Relevance Historical Items

Item NameSold Price
3
 
Vintage Round Tennon bit brace Stanley Bailey log chair dowel shaker hand tools
Very nice Vintage Antique Round tenon, dowel cutter. In excelent working condition with all parts functioning smoothly. No makers marks that I can see. My guess is possibly Bailey or Stanley ?? I thin
$18.50
1
 
Old brass barrel key by Climax mkd L.D. Co. #6
This key measures close to 2" long.
$6.99
1
 
Nice lot of 5 Vintage Axe - Ax / Hammer Heads
Up for auction a nice lot of 5 Vintage Ax / Hammer Heads. All are in very good antique condition. Please view the pictures.
$9.99
1
 
METAL 4 DRAWER STORAGE BIN VINTAGE MACHINE AGE DUNLAP BOX TOOL CABINET HAM RADIO
Normal 0 false false false MicrosoftInternetExplorer4 I must get rid of a few of my possessions to buy my daughter a car and put her through school. I will be listing a lot of Radio Amp and Electronic
$20.00
5
 
Plum Bob for Survay Transet Tool Carpenter Tool Brass Copper & Steel K&E Co.
Bob is marked K&E CO. N. Y. see photo three. This is a working bob with three types of metal. The very top is brass the top middle section looks like copper. The bottom middle is brass and the ver
$85.30
1
 
Stanley G12-060 Wood Plane England
Stanley G12-060 plane is 6-1/4 inches long 1-3/4 wide and made in England . About a 1/8 inch chip on bottom piece at blade slot, see picture with red tipped pen pointing to it. Bottom has several larg
$11.00
2
 
KEEN KUTTER Drawknife - 9 Inch Blade
Check out the pictures below, for some auctions there may be more than shown above. Marked on the back KEEN KUTTER and 9 for the 9 inch blade length. A little light surface rust to clean off and a sha
$12.99
1
 
SNAP - ON 1/4'' DRIVE EXTENSION TMX 140 ( 14 INCHES) IN VERY GOOD CONDITION.
SNAP-ONA 14 INCH LONG EXTENSION FOR 1/4" SOCEKTSTMX 140IN VERY GOOD CONDITION.
$12.99
2
 
C.F. Richardson 6" Machinist's Level
This machinist's level is early (pre-1907), rare, and struck with the "C.F. Richardson" "Athol, Mass" trademark. It retains ~70% or more of its original japanning and bears an uncanny resemblance to a
$24.27
3
 
Lot of Drill Bits and Indexes Chuck Keys
Huge lot of drill bits with drill bit indexes and some chuck keys. The largest bit you see (laying top left) on the table is a 9/16." I counted a little over 140 drill bits in all. The bits (about 10)
$28.03