bidding on this stanley 102 small plane, fits in the palm of your hand. Some of the japanning has worn off, and a little surface rust. Lots of character, look great in the shop, shelf or as a paper we

 

HERE IS A COLLECTABLE LARGE BARN PULLEY MADE OF WOOD AND IRON. THIS IS A VERY LARGE PULLEY THAT WEIGHS 27 POUNDS. THE WOOD HAS A SMALL SPOT THAT HAS NORMAL BARN WEAR AT THE BOTTOM IN THE FORM OF SOME

 

The item offered here is the micrometer holder. But, the micrometer shown, ground off on the back side of the frame, comes with it. The holder is cast iron with a 5/16in slot. The base is 2-3/4in diam

 

VINTAGE LOT OF 3 WOOD WOODWORKING CHISELS Brand: Screw LogoModel: 25m/m, 35m/m, 35m/mChisel Length: 12 3/8", 12 5/8", 13 1/8"Country: Made in Germany Description: Lot of 3 Vintage German Wood Chisels.

 

This auction is for 3 vintage wood handle hammers. One is a cobblers hammer marked Sears and Roebuck, the pointed handled one is an auto body or stone masons hammers, no chips or cracks. The axe hamme

 

This is an excellent wood turning parting tool by Robert Sorby.The 6 1/2" long blade is clean and sharp, total length 17".Blade is 3/4" x 3/16".The ash handle is in very good condition with a good bra

 

Up for auction, an antique rosewood/brass marking gauge in unbelievable excellent condition. It is like it was purchased and forgotten in the work chest for 140 years. There are a few dings and light

 

You are looking at a Vintage Chatillon Hanging Scale with Tray. It is from Feb. 3, 1931 pat. # is 1791111 Weighs up to 40 lbs. It is rusty but it still in working condition! The scale is 8 1/2" in dia

 

THIS MACHINIST LEVEL IS USED BUT IN GOOD CONDITION.THIS LEVEL WAS MADE IN USA IN NEW BRITAIN CONN. THERE ARE A FEW SURFACE RUST SPOTS ON IT.IT NEEDS A GOOD CLEANING AND THERE IS NO NICKS ON IT.

 

SELLING HERE IS A NICE PLOMB 9/16" 1218 COMBO WRENCH. IT IS IN GOOD CONDITION, WITH MINOR WEAR AND FINISH BLEMISHES