I am a commercial General Contractor and recently installed these throughout a local hospital. We had two left over. I kept one for the house! These locks are really cool! They light up when you touch

 

For Sale: Vintage Lenk #750 soldering iron, 150w, with cloth cord, and UL approved. It does work, the replaceable tip does remove, the wood handle and cord are excellent, and at $3.39 Retail, it's eve

 

THIS IS A NO. 224 "SPECIAL REEDING CUTTER" FOR THE STANLEY NO. 45 & 55 COMBINATION PLANE. THIS WILL WORK IN BOTH THE 45 & 55 AND IS ONLY SOLD AS A "SPECIAL CUTTER" FOR BOTH THE NO. 45 AND NO.

 

For sale is a precision drill guide by craftsman. Model 11224. The portalign drill guide will attach to 1/4", 3/8", and 1/2" drill motors having 3/8-24 threaded shaft and with the motor housing not ex

 

This auction is for a rare vintage "TRU-TEST" 1/4" Drive Ratchet. The ratchet is used, shows some light wear and is in good working condition. No.T1060-1 4-5/8" long There are No owners marks. Comes a

 

Super rare patented bevel gauge C. Farn Co. patented April 10, 1877. The patent for this gauge is attributed to J. F. Klingsmith. The square is in good condition for its age. The Rosewood body is beau

 

I am selling a used original Plomb 5449 1/2'' ratchet. It is in good working order. Pebble finish. Selector will go too far to either side but if kept in normal operating areas works fine. It is a 60

 

10 VINTAGE OR SKELETON KEYS. ALL ARE ORIGINAL KEYS MADE FROM METAL STARTING FROM LEFT TO RIGHT IN THE PHOTO ONE HAS A DIFFERENT NUMBER - SIZES ARE APPROXIMATE: 1. 3 1/8 NO 1 ON THE BOTTOM 2. 3 1/4 NO

 

This auction is for a Vintage Winchester Store original cold chisel tool. It is 5 3/4" long and 1/2" wide. The Winchester trade mark logo and part number are stamped on the side of the chisel and read

 

with just a little elbow greese youll have just as good as any one has out there paint is good.... wood is just thirsty... surface rust ... will clean easy blades are a dime a dozen.... great era....